Audi Logo Badge LED Light

Audi Logo Badge LED Light has a consistent appearance with the original car standard, and it can be directly replaced by the original car standard when installed in the car tail box. It is made with the best technology and has a steady emitting light with high transparency and uniform brightness.

Feature:

• The appearance of this product is consistent with the original car standard, and it can be directly replaced by the original car standard when installed in the car tail box. Its special vacuum plating technology not only ensures the same gloss as the original logo but also ensures high transparency and uniform brightness.
• It adopts a high-quality LED lamp set, featuring high brightness and durability. It is specially designed to be waterproof and dustproof to ensure long-term use.
• This product is specially designed for car modification enthusiasts. When the daytime car light is not bright, there is no difference from the original car standard. When the night license plate lighting is turned on, the LED car light will also light up, making the car Marked in the night become dazzling, rich in future technology, highlighting the noble blood of your car.
• Use high-quality car special double-sided adhesive, strong and strong lasting! The LED light inside is especially waterproof and dustproof! LED lamps have a lifespan of up to 100,000 hours.

Feature:

• Voltage:12 (V)
• Size: 7.09*2.28inch  
• Wiring length: 0.6 meters
• Material: ABS plating, 3M glue at the bottom
• Package Contents:1* Audi Logo Badge LED Light

1. Flathead screwdriver

2. Phillips screwdriver

3. Insulating tape

4. Towel

5. Pliers

Audi Logo Badge Installation Steps:

1. First, place a towel next to the tailgate logo, use a flat-blade screwdriver to shake the logo, and use the towel to prevent scratching the surface.

2. Pay attention to peeling off the double-sided rubber first. When squatting, don’t apply too much force. After a little bit, slowly squat down, and clean the car logo and the double-sided tape on the surface,

3. Use a Phillips screwdriver to remove the partition inside the tail box. Note that there are clips in some places. Be careful to remove the baffles to see the various lines.

4. Now install the car standard light, the car standard light power line passes through one of the car standard positioning holes, and wears the single-sided glue on the back of the car standard light inside the car box. While pulling the wire, the car mark light is glued to the vehicle surface, and the pressure is pressed. tight.

5. The car light is installed, and now it is connected to the power supply. The car light should be connected to the power supply of the license plate so that when the night light is turned on the car light will be turned on at the same time, and the power connector of the rear license plate light is found.